Star Micronics TUP900 User Manual download pdf (Page 29)

Rev 0.01

TUP900 Series Specifications Manual

8-1

8. SETTING UP THE PRINTER UNIT

8-1 Mounting the Units

8-1-1 Mounting the Printer Unit

Use the four holes a, b, c and d shown in the external drawing of Fig. 4.1.2 on the separate sheet to fasten

the printer unit.

Also, it is recommended the unit be fastened using M4 screws with washers.

Notes 1)Depending on the state of the surface to which the printer mechanism is fastened, the printer

mechanism can become deformed making it difficult to attain quality prints. Avoid fastening to

surfaces that have bumps or that are uneven.

2) Depending on the condition, it may be possible to use other holes to fasten the printer unit, but

it is recommended that the printer unit be securely fastened. Also, use holes a and b as

references when assembling.

8-1-2 Mounting the High Volume Paper Roll Supply (RHU-T900)

Use the four holes A, B, C and D shown in the external drawing of Fig. 7.2 on the separate sheet, to fasten

the unit.

Also, it is recommended the unit be fastened using M4 screws with washers.

Note 1)Depending on the state of the surface to which the unit is fastened, the unit can become deformed

making it difficult to attain quality prints. Avoid fastening to surfaces that have bumps or that are

uneven.

2)Depending on the condition, it may be possible to use other holes to fasten the high volume paper roll

supply, but it is recommended that it be securely fastened. Also, use holes A and B as references

when mounting.

8-1-3 Mounting the Printer Unit and the High Volume Paper Roll Supply (RHU-T900)

When using the layout type for the vertical type described in section 7-2-1, it is necessary to join the printer unit and the high

volume paper roll supply unit.

Use the printer unit holes a, b, c and d (see Fig. 4.1.2 on the separate sheet) and the RHU-T900 unit holes a’, b’, c’ and d’ (see Fig.

7.2 on the separate sheet) to fasten both units. When doing so, align a with a’, b with b’, c with c’ and d with d’ for assembly.

Also, to fasten the printer unit and RHU-T900 unit, it is recommended that you use the M4 screws with washers and the M4 nuts

with washers.

Note 1)See section 8.1.2 to fasten the high volume paper roll supply (RHU-T900) to the user side frame.

2)There are cases in which assembly can be difficult depending on the order of assembly accompanying the

change in the layout of the control board. Be careful of the order of assembly.

3)The spring base comprised in the high volume paper roll supply (RHU-T900) cannot be used in the

vertical type layout. Assembly the RHU-T900 without the spring base.

The friction springs (2 springs) will be fastened directly to the user side frame.

8-2 Mounting the High Volume Paper Roll Supply (RHU-T900)

With regard to the method used for mounting the optional high volume paper roll supply (RHU-T900), refer

to the installation sheet that accompanies the optional high volume paper roll supply (RHU-T900).

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 49 50

No comments

Star Micronics TUP900 User Manual Page 29