Star Micronics TCP400 Series User Manual download pdf (Page 10)

– 7 –

Cleaning Switch

7-2 Frequency of Use

1. Everyday, or once every 300 prints.

2. If errors occur repeatedly, or if there are printing problems, clean the reader/writer.

3. ThecleaningLEDwillashwhentherehavebeen300printings.Cleanthereader/

writerwhenthisashes.

7-3 How to Use

Use the following procedures to clean the reader/writer.

1. Press the cleaning switch.

2. Dampenthefeltsurfaces(bothside)ofacleaningcardwithoptionalcleaningliquid.

3. Insert the cleaning card from the normal card insertion inlet.

4. Allow the reader/writer to sit for approximately one minute before using again, to al

low

it to dry.

Note: 1. Do not use bent cleaning cards. Using bent cards can cause them to be-

come jammed.

 2. Acleaninguidisnotsuppliedwiththeunit.Therefore,anoptionalclean-

ing

uidoracommerciallyavailableethanol(85%minimumpurity)mustbe

obtained.Toobtaintheoptionalcleaninguid,contactyoursalesagent.

3. The attached cleaning card attains its cleaning effectiveness by absorbing

acleaninguidbeforeuse.Makesuretoallowittoabsorbacleaninguid

before using it for cleaning.



4. Make sureto useethanol witha minimum purity of 85%.If ethanolwith a

lowerpurityisused,itwilltakethecleaningcardalongertimetodry.Ifan

undried cleaning card is inserted into the slot, it could cause a malfunction,

such as card slippage.



5. Cleaning cards can be used approximately 30 times.  Contact your sales

agentiftheyaredamagedorexcessivelydirty.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

No comments

Star Micronics TCP400 Series User Manual Page 10