Star Micronics TUP900 User Manual download pdf (Page 41)

Rev 0.01

TUP900 Series Specifications Manual

9-2

18. This unit is provided with an auto-cutter as standard equipment, but absolutely never approach the

auto-cutter blades while the cutter is operating because it is extremely dangerous. Also, if the cutter

stops, absolutely never touch the blades directly with your fingers.

19. Never unnecessarily disassemble the printer or its parts. When performing maintenance, always check

that the power has been turned OFF before starting your work.

20. The TUP900 series handles all paper widths within specifications. However, the width of paper on the

same mechanism (auto-cutter) is limited to one type.

21. LPS electrical power is used as the drive power for this unit.

9-3 Precautions Concerning Safety

To use this printer safely, you must carefully observe the contents described in the specifications

manual and the following precautions.

Also, we accept absolutely no responsibility for any fires or damages caused by any other type of

use of the apparatus.

1. During or after printing, the surface of the motor is extremely hot. Do not touch directly with your hands.

2. Do not touch the gears or rotating parts while the printer unit is operating.

3. Be very careful because there is the possibility of injury by handling the edges of the printer mechanism

(particularly the metal parts).

4. The yellow caution seal affixed to the front surface of the mechanism unit indicates that the thermal

head is very hot while printing or immediately thereafter, and that the paper tear bar (cutter) or the auto-

cutter are extremely dangerous. Absolutely never touch them directly with your hands. The auto-cutter

particularly is also extremely dangerous when it is operating, so absolutely never put your fingers in or

near the auto-cutter blades or paper discharge outlet.

5. When performing maintenance on the printer mechanism, always unplug the power from its outlet

before starting your work.

6. Absolutely never apply a voltage that exceeds the maximum rating to the power connector.

7. The environment for use must be within the ranges specified in the environment specifications.

8. Do not drop foreign matter with electrical conductivity, such as paper clips, onto the PCB.

9. Do not disassemble or modify the units.

10. Absolutely never place the printer in an unstable location.

11. Never place the printer in a highly humid or dusty environment because there is the danger of printer

failure, fire or electrical shocks.

12. Never place objects or sit on the printer.

13. When not using the printer for an extended period of time, always unplug it for safety.

14. When the mechanism unit and presenter unit are rotating (when open), be careful not to allow your

fingers or hands to get caught in the rotating parts.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 49 50

No comments

Star Micronics TUP900 User Manual Page 41